Special Structural Products

For solving truss height problems

Eliminator MKIII

Eliminates T-Stiffeners or web braces on long compression webs

The Eliminator MkIII is designed to replace timber T-stiffeners and web ties on long webs or compression webs which are carrying high loads.

Eliminator MkIII is very useful in circumstances where web braces cannot be tied back to a rigid part of the structure.

The design of webs with the Eliminator MkIII is included in the MiTek truss design software.

USES
  • Stiffens long slender webs under compression against buckling out of plane.
  • Replaces timber T-Stiffeners and lateral binders.
ADVANTAGES
  • May be fitted to web prior to truss assembly, or immediately after truss assembly at plant, or later on site.
  • Width matches timber thickness to facilitate stacking of trusses.
  • Rounded ends to ease fitting in tight places, and prevent injury.
  • Easy fixing with screws.

ELIMINATOR MKIII FULL DATA SHEET

DOWNLOAD

HingePlate

For solving truss height problems

By designing truncated trusses and using extended top chords with a hinge plate joint, very high trusses can be easily manufactured in standard truss jigs. Once manufactured top chords can be bent to reduce the overall height and assist with the transport and installation of very high trusses.

This is particularly useful for large span trusses and trusses with high pitches such as attic trusses.

USES
  • HingePlate provides a flexible connection to assist with the manufacture of very high trusses that cannot be produced on existing pressing equipment.
ADVANTAGES
  • Eliminates over width problems when transporting.
  • Avoids the costly and time consuming alternative of producing ‘piggy-back’ trusses.

HINGE PLATE FULL DATA SHEET

DOWNLOAD

POSI-STRUT
SHORT WALL BRACE KIT

Smarter way to brace short or narrow walls—designed for speed, simplicity and structural confidence

Engineered to deliver the same bracing performance as steel, the Posi-Strut Short Wall Brace comes pre-fabricated in the wall frame by your trusted MiTek fabricator. That means no steel contractors, no lead times and no slab rework—just a complete system, ready to install.

ADVANTAGES
  • Fully engineered solution that meets structural performance requirements while reducing onsite complexity
  • Comes in a convenient kit – contains 2 x boots, 2 square washers, 30 MiTek MSA screws and an installation sticker guide that can be adhered to concrete
  • Independently tested at QUT and fully compliant with AS1720

POSI-STRUT SHORT WALL BRACE FULL DATA SHEET

DOWNLOAD

HIGH CAPACITY HOLD DOWN PLATE

Engineered Strength. Simplified Installation

For fabricators and builders operating in high-wind regions, the MiTek High Capacity Hold Down Plate is the engineered tie-down solution that delivers superior strength, simpler installation, and environmental efficiency — all from the brand you already trust. It is an engineered steel connection designed to provide secure tie-down between the roof, wall and foundation — critical in high-wind and cyclonic regions.

It is a single-piece plate that delivers high load capacity (35kN–100kN) without the need for additional dome washers or multi-component kits. Developed to meet NCC25 requirements for direct connection from roof to foundation, the plate meets all relevant serviceability and galvanisation standards for cyclonic design.

Why High Capacity Hold Down Plates are right for your next build?
  • Stronger performance – higher capacity, tested to meet and exceed current products in the market
  • Simpler to install – one-piece design reduces labour and risk on site.
  • Smarter for the environment – minimal packaging, no plastic waste.
  • Made for cyclonic conditions – built for compliance and confidence.

High Capacity Hold Down Plates FULL DATASHEET

DOWNLOAD